Asus Vintage PE1 User Manual download pdf (Page 24)

2-202-20

2-20

Chapter 2: Basic installationChapter 2: Basic installation

Chapter 2: Basic installation

2.8 Installing a hard disk drive

The system may have one pre-installed 3.5-inch Serial ATA or IDE hard disk

drive. Refer to this section to install up to three additional Serial ATA hard

disk drives, or up to two IDE hard disk drives.

To install a Serial ATA hard disk drive:

1. Place the chassis upright.

2. With the HDD label side up,

carefully insert the drive into

the 3.5-inch bay.

3. Push the drive into the bay

until its screw holes align with

the holes on the drive bay.

HDD screw holesHDD screw holes

HDD screw holes

4. Secure the drive with two

screws on both sides.

5. Connect one end of the Serial

ATA cable to the SATA

connector at the back of the

drive, then connect the other

end to a Serial ATA connector

on the motherboard. See page

4-7 for the location of the

Serial ATA connectors.

3 3

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 83 84

No comments

Asus Vintage PE1 User Manual Page 24