Asus P5KPL-AM IN/ROEM/SI User Manual download pdf (Page 20)

2. IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are

three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray.

Connect the blue connector to the motherboard’s IDE connector, then select one of the

following modes to congure your device.

P5KPL-AM IN

PRI_IDE

NOTE:Orient the red markings

on the IDE ribbon cable to PIN 1.

PIN1

P5KPL-AM IN IDE connector

Driver Jumper setting Mode of device(s) Cable connector

Single device Cable-Selected or Master - Black

Two devices Cable-Select Master Black

Slave Gray

Master Master Black or gray

Slave Slave

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA

cable connector. This prevents incorrect insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as

“Cable-Select,” ensure that all other

device jumpers have the same

setting.

3. USB connectors (10-1 pin USB56, USB78)

These connectors are for USB 2.0 ports. Connect the USB module cable to any of

these connectors, then install the module to a slot opening at the back of the system

chassis. These USB connectors comply with USB 2.0 specication that supports up to

480 Mbps connection speed.

P5KPL-AM IN

P5KPL-AM IN USB2.0 connectors

PIN 1

USB+5V

USB_P8-

USB_P8+

GND

USB+5V

USB_P7-

USB_P7+

GND

USB78

PIN 1

USB+5V

USB_P6-

USB_P6+

GND

USB+5V

USB_P5-

USB_P5+

GND

USB56

Never connect a 1394

cable to the USB

connectors. Doing so will

damage the motherboard!

The USB module cable

is purchased separately.

1-11 ASUS P5KPL-AM IN

1 ... 19 20 21 ... 40

Comments to this Manuals

No comments

Asus P5KPL-AM IN/ROEM/SI User Manual Page 20

Comments to this Manuals

Related products and manuals for Motherboard Asus P5KPL-AM IN/ROEM/SI