4-11ASUS V-Series P5G33
10. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends
a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
P5K-VM
®
P5K-VM Chassis intrusion connector
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)
11. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module
that supports either HD Audio or legacy AC`97 audio standard.
Connect one end of the front panel audio I/O module cable to this
connector.
•
We recommend that you connect a high-denition front panel audio
module to this connector to avail of the motherboard’s high-denition
audio capability.
•
If you want to connect a high-denition front panel audio module
to this connector, set the Front Panel Type item in the BIOS setup
to [HD Audio]; if you want to connect an AC'97 front panel audio
module to this connector, set the item to [AC'97]. By default, this
connector is set to [HD Audio]. See section 2.4.5 Onboard Devices
Conguration for details.
P5K-VM
®
P5K-VM Analog front panel connector
AAFP
Legacy AC ‘97 audio
pin definition
SENSE2_RETUR
PORT1 L
PORT2 R
PORT2 L
SENSE1_RETUR
SENSE_SEND
PORT1 RPRESENCE#
GND
NC
MIC2
Line out_R
Line out_L
NC
NC
MICPWRNC
AGND
HD Audio-compliant
pin definition
Comments to this Manuals