Asus SP98-XV User Manual download pdf (Page 35)

ASUS SP98-N User’s Manual 35

3. HARDWARE SETUP

Connectors

3. H/W SETUP

5) 3.5” Floppy Disk Drive Connector

This connector supports the provided floppy drive ribbon cable. After connect-

ing the single end to the riser card, connect the other end to a 3.5” floppy disk

drive. (Pin 5 is removed to prevent inserting in the wrong orientation when

using ribbon cables with pin 5 plugged).

Floppy Disk Drive Connector

Orient the red stripe on the

floppy ribbon cable to Pin 1

Pin 1

NLX-R (Front)

Yeong-Yang (Front)

NLX-R

YEONG-YANG

Pin 1

Yeong-Yang Risers

NLX-R Riser

6) Universal Serial Bus (USB) Ports / USB Module Connector

If you have the NLX-R or B9-N risers, two Universal Serial Bus (USB) ports

are available for connecting USB devices. If you have the Yeong-Yang riser, a 5-

pin block is available for connecting an external connector set. This connector

set can be mounted to an open slot on your computer’s chassis. USB Function

must be set to Enabled and USB IRQ to Auto in 4.4.3 PCI Configuration to

use USB features.

Universal Serial Bus (USB) Ports / USB Module Connector

NLX-R (Back)

Yeong-Yang (Front)

YEONG-YANG

1: USB +5 Volt

2: (no connection)

3: USB Port 0+

4: USB Port 0-

5: USB +5Volt

The USB ports show

through the front

panel

Port 1 Port 2

NLX-R Riser

Yeong-Yang Riser

1 ... 34 35 36 ... 112

No comments

Asus SP98-XV User Manual Page 35