Asus K8V-VM Ultra User's Guide download pdf (Page 31)

ASUS K8V-VM Ultra Motherboard 1-21

Single device Cable-Select or Master - Black

Two devices Cable-Select Master Black

Slave Gray

Master Master

Slave Slave

2. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)

The onboard IDE connectors are for Ultra DMA 133/100/66 signal cables.

There are three connectors on each Ultra DMA 133/100/66 signal cable:

blue, black, and gray. Connect the blue connector to the motherboard’s IDE

connector, then select one of the following modes to conﬁgure your device(s).

• Pin 20 on the IDE connector is removed to match the covered hole on the

Ultra DMA cable connector. This prevents incorrect insertion when you

connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select,” make sure all other device

jumpers have the same setting.

K8V-VM ULTRA IDE Connector

PRI_IDE

SEC_IDE

K8V-VM ULTRA

Black or gray

Drive jumper Mode Cable

setting of devices connector

1 ... 30 31 32 ... 78

No comments

Asus K8V-VM Ultra User's Guide Page 31