Asus P4P800S-X User's Guide download pdf (Page 28)

1-18

Chapter 1: Product introduction

1.10.2 Internal connectors

1. IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)

This connector supports the provided UltraATA100 IDE hard disk ribbon cable.

Connect the cable’s blue connector to the primary (recommended) or secondary

IDE connector, then connect the gray connector to the UltraATA100 slave device

(hard disk drive) and the black connector to the UltraATA100 master device.

1. Follow the hard disk drive documentation when setting the device in master

or slave mode.

2. Pin 20 on each IDE connector is removed to match the covered hole on the

UltraATA cable connector. This prevents incorrect orientation when you

connect the cables.

3. The hole near the blue connector on the UltraATA cable is intentional.

2. Floppy disk drive connector (34-1 pin FLOPPY1)

This connector supports the provided floppy drive ribbon cable. After

connecting one end to the motherboard, connect the other end to the floppy

drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables

with pin 5 plug).

P4P800S-X

P4P800S-X IDE Connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

SEC_IDE

PIN 1

PRI_IDE

PIN 1

P4P800S-X

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

P4P800S-X Floppy Disk Drive Connector

FLOPPY

PIN 1

1 ... 27 28 29 ... 70

No comments

Asus P4P800S-X User's Guide Page 28