2-20 Chapter 2: Basic installation
3. Connect the gray interface of the IDE ribbon cable to the IDE
connector on the drive.
4. If you install two IDE hard disk drives, connect the black interface of
the IDE ribbon cable to the IDE connector on the second (Slave) IDE
hard disk drive.
5. Connect a 4-pin power plug from the power supply unit to the power
connector at the back of the drive(s).
• If you will install only one hard disk drive, make sure to congure your
hard disk drive as Master device before connecting the IDE cable and
power plug. Refer to the HDD documentation on how to set the drive
as a Master device.
• If you will install two IDE hard disk drives, congure the other device
as Slave.
2.9 Installing the card reader
An optional card reader module (see the gure below) is available with the
system. If you want to install the card reader into your system, follow the
steps on the next page.
Note: the card reader is optional and users need to purchase separately.
Comments to this Manuals