Asus TX97 User Manual download pdf (Page 44)

ASUS TX97-E User’s Manual44

(Chipset Features)

IV. BIOS SOFTWARE

IV. BIOS

(Chipset Features)

SDRAM CAS# Latency (3T)

If you use ASUS SDRAM DIMM modules, you can set this to 2T for better perfor-

mance, otherwise leave on default or check with your vendor for DIMM specs.

SDRAM Speculative Read (Disabled)

If Enabled, the CPU will issue predict commands to access the DRAM, if a miss

occurs, the CPU will cancel this command. Some operating systems under certain

situations have a problem utilizing this feature so it is normally Disabled.

Passive Release (Enabled)

This is a mechanism that allows concurrency of ISA/EISA cycles and CPU-to-PCI

cycles. When this feature is enabled, the TXC will be possible to re-arbitrate PCI

bus and allow the CPU to access PCI even when the PCEB has been granted the bus.

Delayed Transaction (Disabled)

If Enabled, this frees the PCI Bus during CPU accessing of 8-bit ISA cards which

normally consume about 50-60 PCI Clocks without PCI delayed transaction. If PCI

Bus Masters cannot use the PCI Bus, leave this on the default setting of Disabled for

some ISA cards that are not PCI 2.1 compliant.

16-bit I/O Recovery Time (1 BUSCLK)

Timing for 16-bit ISA cards

8-bit I/O Recovery Time (1 BUSCLK)

Timing for 8-bit ISA cards

Video BIOS Cacheable (Enabled)

Allows the Video BIOS to be cached to allow faster execution. Leave on default

setting of Enabled for better performance, otherwise Disabled.

Memory Hole at Address (None)

This features reserves either 14MB-16MB or 15MB-16MB memory address space to

ISA expansion cards that specifically require this setting. Memory from 14MB and up

or 15MB and up will be unavailable to the system because expansion cards can only

access memory up to 16MB.

....................................................................................................................................

Onboard FDC Controller (Enabled)

When enabled, this field allows you to connect your floppy disk drives to the on-

board floppy drive connector instead of a separate controller card. If you want to use

a different controller card to connect the floppy drives, set this field to Disabled.

Onboard FDC Swap A: B: (No Swap)

This field allows you to reverse the hardware drive letter assignments of your floppy

disk drives. Two options are available: Swap AB and No Swap (default). If you want

to switch drive letter assignments, set this field to Swap AB, and the swap will be

controlled by the onboard chipset.

1 ... 43 44 45 ... 64

Comments to this Manuals

No comments

Asus TX97 User Manual Page 44

Comments to this Manuals

Related products and manuals for Motherboards Asus TX97