Asus Digital Entertainment PC AB-V100 Specifications download pdf (Page 103)

Appendix

A-3

A.1.2 Removing the top cover

To remove the top cover:

1. On the Subsystem rear panel, locate the two screws that secure the

top cover to the chassis.

2. Use a Phillips (cross) screw driver to remove the top cover screws.

Keep the screws for later use.

3. Pull the top cover slightly toward the rear panel until the side tabs are

disengaged from the chassis.

4. Hold the center edge of the top cover, then lift it up from the chassis.

Set the top cover aside.

A.1.3 Installing a hard disk drive

1. Connect the 40-pin IDE cable

to the IDE connector on the

drive.

2. Connect the 4-pin power plug

to the HDD power connector.

Set your hard disk drive as Slave device before connecting the IDE cable

and power plug. Refer to the HDD documentation on how to set the drive

as a slave device.

To install a hard disk drive:

3. Place the drive on the tray.

4. Secure the drive with two side

screws.

5. Replace the top cover.

1 ... 102 103 104 ... 112

No comments

Asus Digital Entertainment PC AB-V100 Specifications Page 103