Asus CUR-DLSR User Manual download pdf (Page 76)

ASUS CUR-DLSR User’s Manual

5. Motherboard Driver Installation

5. Driver Installation

WinNT4.0 Server

B1. CD-ROM Installation

1. Start the Windows NT installation by booting from the Windows NT CD-ROM.

The system BIOS must support booting from a CD-ROM. LSI BIOS settings

may need to be changed to allow CD-ROM booting when using a SCSI CD-

ROM drive.

2. When the screen displays “Windows NT Setup”, immediately press the F6

key. This must be done or else the new driver installed from the LSI driver

diskette will not be recognized.

Note: If F6 is not pressed, the user is still given the opportunity to load addi-

tional drivers later in the installation process. However, any driver loaded dur-

ing Windows NT Setup are not immediately recognized and no devices con-

trolled by that driver are available during Windows NT Setup.

3. When prompted for the manufacturer-supplied hardware support disk, insert

the appropriate LSI driver diskette containing the Windows NT driver required

to support your LSI adapter(s) and press Enter. The driver files are distributed

with ASUS Driver Support CD and are created from above “Preparing a LSI

Driver Diskette” Section.

4. Depending on the driver being installed, either “LSI PCI High Performance

Driver”, or “LSI Logic Ultra3 PCI SCSI Driver” is shown highlighted. Press

Enter to proceed.

5. Windows NT should now recognize the miniport driver(s) and the SCSI hard-

ware. Press Enter to continue. At this point, simply follow the Microsoft Win-

dows NT installation procedure. As for the onboard LAN and VGA, please

refer to the later sections for network and graphics driver installation.

B2. Boot Floppy Disk Installation

1. Start the Windows NT installation by booting from the Microsoft Setup floppy

diskette.

2. Press Enter when the Welcome to Setup screen appears. The Windows NT

Workstation Setup window appears next.

3. Press S to skip automatic detection and perform a manual selection. A screen

displays the message “Setup has recognized the following mass storage de-

vices in your computer...”.

4. With floppy disk 2, there is an initial setup screen that prompts you to continue

by pressing Enter.

5. Press S to skip mass storage device detection. (If Enter is pressed, the installa-

tion program scans for SCSI adapters and finds the LSI PCI (53C810) driver

which is an older version of the SYMC8XX.SYS driver. Let installation con-

tinue and change the driver when the installation is completed.) To change the

driver, see Existing System Installation.

1 ... 75 76 77 ... 104

Comments to this Manuals

No comments

Asus CUR-DLSR User Manual Page 76

Comments to this Manuals

Related products and manuals for Servers Asus CUR-DLSR