Asus P5KPL SE User Manual download pdf (Page 31)

ASUS P5KPL SE 1-21

4. Digital audio connector (4-1 pin SPDIF_OUT)

This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect

the S/PDIF Out module cable to this connector, then install the module to a slot

opening at the back of the system chassis.

The S/PDIF module is purchased separately.

3. IDE connector (40-1 pin PRI_EIDE)

The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are

three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray.

Connect the blue connector to the motherboard’s IDE connector, then select one of the

following modes to congure your device.

Drive jumper setting Mode of device(s) Cable connector

Single device Cable-Select or Master - Black

Two devices

Cable-Select

Master Black

Slave Gray

Master Master

Black or gray

Slave Slave

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA

cable connector. This prevents incorrect insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices.

If any device jumper is set as

“Cable-Select,” make sure all other

device jumpers have the same

setting.

P5KPL SE

PRI_IDE

NOTE:Orient the red markings

on the IDE ribbon cable to PIN 1.

PIN1

P5KPL SE IDE connector

P5KPL SE

SPDIF_OUT

+5V

SPDIFOUT

GND

P5KPL SE Digital audio connector

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 59 60

No comments

Asus P5KPL SE User Manual Page 31