Asus Z8PE-D18 User Manual download pdf (Page 56)

2-38 Chapter 2: Hardware information

15. Auxiliary panel connector (20-pin AUX_PANEL1)

This connector is for additional front panel features including front panel

SMB, locator LED and switch, chassis intrusion, and LAN LEDs.

1. Front panel SMB (6-1 pin FPSMB)

These leads connect the front panel SMBus cable.

2. LAN activity LED (2-pin LAN1_LED, LAN2_LED

)

These leads are for Gigabit LAN activity LEDs on the front panel.

3. Chassis intrusion (4-1 pin CHASSIS)

These leads are for the intrusion detection feature for chassis with

intrusion sensor or microswitch. When you remove any chassis

component, the sensor triggers and sends a high-level signal to these

leads to record a chassis intrusion event. The default setting is short

CASEOPEN and GND pin by jumper cap to disable the function.

4. Locator LED (2-pin LOCATORLED1 and 2-pin LOCATORLED2)

These leads are for the locator LED1 and LED2 on the front panel.

Connect the Locator LED cables to these 2-pin connector. The LEDs will

light up when the Locator button is pressed.

5. Locator Button/Swich (2-pin LOCATORBTN)

These leads are for the locator button on the front panel. This button

queries the state of the system locator.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 163 164

No comments

Asus Z8PE-D18 User Manual Page 56