Asus Dual Pentium III Group Server AP200 User Manual download pdf (Page 16)

III. Getting Started

AP200 Hardware Reference Guide

III. Getting Started

Startup / LED / BIOS

3-1. Starting the Server

Turn on the system unit by turning the power knob clockwise and pushing

inwards momentarily. The power button will snap back because ATX power

systems have an electrical On/Off switch unlike AT systems which require a

permanent On or Off position. If the Power On LED does not light, make

sure the power cord is connected to the system unit and to a working grounded

outlet.

IMPORTANT

The power switch only turns off DC power (power supply out-

put). To turn off AC power (power supply input), you need to

unplug the electrical cords from the power supply.

3-2. LED Indicators

Three green LED indicators are located on the top of the front panel. When lit,

the “Message” shows the status of the modem, fax, email, or voice mail as

determined by your ACPI OS and software. “Power On” lights when the moth-

erboard receives power from the power supply. “Drive Activity” lights when

there is activity from IDE or SCSI devices connected to the motherboard.

3-3. BIOS Setup

This server does not come with any pre-installed software. When booting

your server for the first time, make BIOS settings by following the mother-

board User’s Manual.

Drive Activity

Message

Power On

LED Indicators on the Front Panel

When installing Windows NT 4.0 or higher operation system,

use the Windows NT installation floppy disks. Installing from

the CD will require you to pre-install SCSI drivers by pressing

<F6> before Setup begins.

NOTE

1 ... 15 16 17 ... 32

No comments

Asus Dual Pentium III Group Server AP200 User Manual Page 16