Asus P/I-P65UP8/CP6ND User Manual download pdf (Page 24)

24 ASUS P/I-P65UP8 User’s Manual

III. INSTALLATION

(Connectors)

III. INSTALLATION

5. External Connectors

IMPORTANT: Connect ribbon cables such that the red stripe is on the pin 1 side of

the connector. The four corners of the connectors are labeled on the baseboard. Pin

1 is the side closest to the power connector on hard and floppy disk drives. IDE

ribbon cable must be less than 18in. (46cm), with the second drive connector no

more than 6in. (15cm) from the first connector.

1. Keyboard Connector (5-pin KBCON)

This connector is for either a standard IBM-compatible, 101/102-key, or 104-

key (Windows 95-compatible) keyboard. Use either the AT keyboard connector

on the baseboard or PS/2 keyboard connector on the CPU card.

Connector Plug

from Keyboard

Keyboard Connector

(5-pin female)

Keyboard Connector

PS/2 Keyboard

Port (CPU Card)

PS/2 Mouse

Port (CPU Card)

2. Floppy Disk Drive Connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connect-

ing the single end to the board, connect the two plugs on the other end to the

floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-

tion when using ribbon cables with pin 5 plugged).

Floppy Disk Drive Connector

Orient the red stripe on the

floppy ribbon cable to Pin 1

Pin 1

WARNING! Some pins are used for connectors or power sources. These are

clearly differentiated from jumpers as shown in the baseboard layout on page

10. Placing jumper caps over these pins will cause damage to your baseboard.

1 ... 23 24 25 ... 40

No comments

Asus P/I-P65UP8/CP6ND User Manual Page 24