32 ASUS P/I-P65UP8 User’s Manual
III. INSTALLATION
(Connectors)
III. INSTALLATION
20. Main and Auxilliary AT Power Connectors (12-pin & 6-pin PWRCON)
This connector connects to a standard 5 Volt power supply. To connect the leads
from the power supply, ensure first that the power supply is not plugged. Most
power supplies provide two plugs (P8 and P9), each containing six wires, two of
which are black. An auxilliary connector (P10) is provided in case the power
supplied through the main connectors are insufficient. Orient the main connec-
tors so that the black wires are located in the middle.
AT Power Connector
R
Power Plugs from
Power Supply
Power Connector
on Motherboard
P9
P8
ORG
RED
YLW
BLU
BLK
BLK
BLK
BLK
WHT
RED
RED
RED
P10
PG
+12Volts
-12Volts
-5Volts
+5Volts
Ground
Ground
+5Volts
+5Volts
RED
RED
RED
BLK
BLK
BLK
Using a slight angle, align the plastic guide pins on the lead to their receptacles
on the connector. Once aligned, press the lead onto the connector until the lead
locks into place.
21. ATX Power Supply Connector (20-pin ATXPWR)
This connector connects to a ATX power supply. The plug from the power
supply will only insert in one orientation because of the different hole sizes.
Find the proper orientation and push down firmly making sure that the pins are
aligned.
IMPORTANT: Be sure that the ATX power supply can take at least 10mAmp
load on the 5volt standby lead (5VSB). You may experience difficulty in
powering on your system without this.
+3.3 Volts
-12.0 Volts
Ground
Power Supply On
Ground
Ground
Ground
-5.0 Volts
+5.0 Volts
+5.0 Volts
Power Good
+12.0 Volts
+3.3 Volts
+3.3 Volts
Ground
+5.0 Volts
Ground
5.0 Volts
Ground
+5V Standby
ATX Power Connector
R
Power Connector
on Motherboard
Comments to this Manuals