Asus P7H55/USB3 User Manual Page 46

  • Download
  • Add to my manuals
  • Print
  • Page
    / 70
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 45
2-6 Chapter 2: BIOS information
32Bit Data Transfer [Enabled]
[Enabled] Sets the IDE controller to combine two 16-bit reads from the hard disk
into a single 32-bit double word transfer to the processor. This makes
more efcient use of the PCI bus as fewer transactions are needed for the
transfer of a particular amount of data.
[Disabled] Disables this function.
2.3.2 Storage Conguration
The Storage Conguration menu allows you to congure your storage devices. Select an
item then press <Enter> to display the submenu.
SATA Conguration [Enhanced]
Conguration options: [Disabled] [Compatible] [Enhanced]
Configure SATA as [IDE]
Sets the conguration for the Serial ATA connectors supported by the Southbridge chip.
Conguration options: [IDE] [AHCI]
If you want to use the Serial ATA hard disk drives as Parallel ATA physical storage
devices, keep the default setting [IDE].
If you want the Serial ATA hard disk drives to use the Advanced Host Controller Interface
(AHCI), set this item to [AHCI]. The AHCI allows the onboard storage driver to enable
advanced Serial ATA features that increases storage performance on random workloads
by allowing the drive to internally optimize the order of commands.
Hard Disk Write Protect [Disabled]
Disables or enables device write protection. This will be effective only if the device is
accessed through BIOS. Conguration option: [Disabled] [Enabled]
IDE Detect Time Out (Sec) [35]
Selects the time out value for detecting ATA/ATAPI devices. Conguration options: [0] [5] [10]
[15] [20] [25] [30] [35]
2.3.3 AHCI Conguration
This menu is the section for AHCI conguration. It appears only when you set the item
Congure SATA as from the sub-menu of SATA Conguration to [AHCI].
SATA Port1–6 [XXXX]
Displays the status of auto-detection of SATA devices.
SATA Port1 [Auto]
Allows you to select the type of device connected to the system.
Conguration options: [Auto] [Not Installed]
SMART Monitoring [Enabled]
Allows you to set the Self-Monitoring, Analysis and Reporting Technology.
Congration options: [Disabled] [Enabled]
Page view 45
1 ... 45 46 47 ... 70

Comments to this Manuals

No comments