Asus 810 User Manual download pdf (Page 36)

36 ASUS CUW User’s Manual

Connectors

3. H/W SETUP

3. HARDWARE SETUP

14) IDE Activity LED Lead (2-pin IDELED)

This lead supplies power to the cabinet’s IDE activity LED. Read and write

activity by devices connected to the Primary or Secondary IDE connectors will

cause the LED to light up.

0 10 10 1

CUW

CUW IDE Activity LED

TIP: If the case-mounted LED does not

light, try reversing the 2-pin plug.

IDELED

15) Chassis, CPU, & Power Supply Fan Connectors (3-pin CHA_, CPU_, PWR_FAN)

These connectors support cooling fans of 350mA (4.2 Watts) or less. Orientate

the fans so that the heat sink fins allow airflow to go across the onboard heat

sink(s) instead of the expansion slots. Depending on the fan manufacturer, the

wiring and plug may be different. The red wire should be positive, while the

black should be ground. Connect the fan’s plug to the board taking into consid-

eration the polarity of the connector.

NOTE: The “Rotation” signal is to be used only by a specially designed fan with

rotation signal. The Rotations per Minute (RPM) can be monitored using ASUS PC

Probe Utility or Intel LDCM Utility (see 6. SOFTWARE REFERENCE).

WARNING! The CPU and/or motherboard will overheat if there is no airflow

across the CPU and onboard heatsinks. Damage may occur to the motherboard

and/or the CPU fan if these pins are incorrectly used. These are not jumpers,

do not place jumper caps over these pins.

1 ... 35 36 37 ... 128

No comments

Asus 810 User Manual Page 36