Asus CUSL2K User Manual download pdf (Page 54)

ASUS CUSL2K User’s Manual54

4. BIOS SETUP

IMPORTANT: If your hard disk was already formatted on an older previous system,

incorrect parameters may be detected. You will need to enter the correct parameters

manually or use low-level format if you do not need the data stored on the hard disk.

If the parameters listed differ from the ones used when the disk was formatted, the

disk will not be readable. If the auto-detected parameters do not match the ones that

should be used for your disk, you should enter the correct ones manually by setting

[User Type HDD].

Master/Slave Drives

[User Type HDD]

Manually enter the number of cylinders, heads and sectors per track for

your drive. Refer to your drive documentation or look on the drive for this

information. If no drive is installed or if you are removing a drive and not

replacing it, select [None].

Translation Method [LBA]

Select the hard disk drive type in this field. When Logical Block Address-

ing is enabled, 28-bit addressing of the hard drive is used without regard

for cylinders, heads, or sectors. Note that LBA Mode is necessary for drives

with greater than 504MB in storage capacity. Configuration options: [LBA]

[LARGE] [Normal] [Match Partition Table] [Manual]

Cylinders

This field configures the number of cylinders. Refer to your drive docu-

mentation to determine the correct value to enter into this field. NOTE: To

make changes to this field, the Type field must be set to [User Type HDD]

and the Translation Method field must be set to [Manual].

1 ... 53 54 55 ... 122

No comments

Asus CUSL2K User Manual Page 54