Asus P2Z-B User Manual download pdf (Page 31)

ASUS P2Z-B User’s Manual 31

III. HARDWARE SETUP

7. Chassis, CPU , & Power Supply Fan Connectors (3-pin CHA_, CPU_, PWR_FAN)

These connectors support cooling fans of 500mA (6 Watts) or less. Orientate

the fans so that the heat sink fins allow airflow to go across the onboard heat

sink(s) instead of the expansion slots. Depending on the fan manufacturer, the

wiring and plug may be different. The red wire should be positive, while the

black should be ground. Connect the fan’s plug to the board taking into consid-

eration the polarity of the this connector. NOTE: The “Rotation” signal is to

be used only by a specially designed fan with rotation signal.

WARNING! These connectors have power. Damage may occur to the mother-

board and/or the CPU fan if these connectors are incorrectly used.

P2Z-B 12Volt Cooling Fan Power

Chassis Fan Power (CHA_FAN)

Power Supply Fan (PWR_FAN)

CPU Fan Power (CPU_FAN)

GND

Rotation

+12V

P2Z-B

GND

Rotation

+12V

GND

Rotation

+12V

8. Wake-On-LAN Connector (3-pin WOL_CON)

This connector connects to a LAN card with a Wake-On-LAN output, such as

the ASUS PCI-L101. The LAN card powers up the system when a wakeup

packet or signal is received from the network.

IMPORTANT: This feature requires that the WAKE On LAN Power Up Con-

trol is set to Enabled (see Power Management Setup under BIOS SETUP) and

that your system has an ATX power supply with at least 720mA +5V standby

power.

P2Z-B Wake-On-LAN Connector

+5 VSB

PME

Ground

P2Z-B

Connectors

III. H/W SETUP

1 ... 30 31 32 ... 96

No comments

Asus P2Z-B User Manual Page 31