Asus P2Z-B User Manual download pdf (Page 34)

34 ASUS P2Z-B User’s Manual

III. HARDWARE SETUP

Connectors

III. H/W SETUP

18. Wake-On-Ring Connector (2-pin WOR)

This connector connects to internal modem cards with a Wake-On-Ring output.

The connector powers up the system when a ringup packet or signal is received

through the internal modem card. NOTE: For external modems, Wake-On-Ring

is detected through the COM port.

IMPORTANT: This feature requires that PWR UP On Modem Act Power Up Con-

trol is set to Enabled (see Power Management Setup under BIOS SETUP) and that your

system has an ATX power supply with at least 720mA +5V standby power.

P2Z-B Wake-On-Ring Connector

WOR

P2Z-B

Pin 1 Ground

Pin 2 PIXRI#

19. Chassis Intrusion Sensor Lead (4-1 pin CHASIS)

This lead is for a chassis intrusion monitor or sensor. The sensor is triggered

when a high level signal is sent to the “chassis signal” lead. This occurs when a

panel switch or light detector is triggered. This function requires the optional

ASUS CIDB Chassis Intrusion Photo Sensor Module (see APPENDIX) to be

installed.

P2Z-B Chassis Open Alarm Lead

+5Volt (Power Supply Stand By)

Ground

Chassis Signal

P2Z-B

1 ... 33 34 35 ... 96

No comments

Asus P2Z-B User Manual Page 34