Asus P2Z-B User Manual download pdf (Page 36)

36 ASUS P2Z-B User’s Manual

III. HARDWARE SETUP

Connectors

III. H/W SETUP

22. ATX Power Supply Connector (20-pin ATXPWR)

This connector connects to an ATX power supply. The plug from the power sup-

ply will only insert in one orientation because of the different hole sizes. Find the

proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT: Make sure that your ATX power supply can supply at least

10mA on the 5-volt standby lead (+5VSB). You may experience difficulty in

powering on your system if your power supply cannot support the load. For

Wake-On-LAN support, your ATX power supply must supply at least 720mA.

P2Z-B ATX Power Connector

P2Z-B

+3.3 Volts

-12.0 Volts

Ground

Power Supply On

Ground

-5.0 Volts

+5.0 Volts

Power Good

+12.0 Volts

+3.3 Volts

Ground

+5.0 Volts

Ground

+5.0 Volts

Ground

+5V Standby

23. AT Power Supply Connector (12-pin PS/2)

This connector connects to a standard 5 Volt power supply. To connect the leads

from the power supply, ensure first that the power supply is not plugged. Most

power supplies provide two plugs (P8 and P9), each containing six wires, two of

which are black. Orient the connectors so that the black wires are together.

P2Z-B AT Power Connector

P2Z-B

Power Plugs from

Power Supply

Power Connector

on Motherboard

ORG

RED

YLW

BLU

BLK

WHT

RED

+5V

+12V

GND

+5V

-12V

-5V

Using a slight angle, align the plastic guide pins on the lead to their receptacles

on the connector. Once aligned, press the lead onto the connector until the lead

locks into place.

1 ... 35 36 37 ... 96

Comments to this Manuals

No comments

Asus P2Z-B User Manual Page 36

Comments to this Manuals

Related products and manuals for Motherboards Asus P2Z-B