Asus A7VL-VM User Manual download pdf (Page 57)

ASUS A7VL-VM User’s Manual 57

4. BIOS SETUP

Onboard FDC Swap A & B [No Swap]

This field allows you to reverse the hardware drive letter assignments of your floppy

disk drives. Configuration options: [No Swap] [Swap AB]

Floppy Disk Access Control [R/W]

When set to [Read Only], this field protects files from being copied to floppy disks

by allowing reads from the floppy disk drive but not writes. The setup default [R/W]

allows both reads and writes. Configuration options: [R/W] [Read Only]

Onboard Serial Port 1 [3F8H/IRQ4]

Onboard Serial Port 2 [2F8H/IRQ3]

These fields allow you to set the addresses for the onboard serial connectors. Serial

Port 1 and Serial Port 2 must have different addresses. Configuration options: [3F8H/

IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/IRQ10] [Disabled]

UART2 Use Infrared [Disabled]

When enabled, this field activates the onboard standard infrared feature and sets

the second serial UART to support the infrared module connector on the mother-

board. If your system already has a second serial port connected to the onboard

COM2 connector, it will no longer work if you enable the infrared feature. See

Standard and Consumer Infrared Module Connector in 3.8 External Connec-

tors. Configuration options: [Disabled] [Enabled]

4.4.2 I/O Device Configuration

I/O Device Config

1 ... 56 57 58 ... 92

No comments

Asus A7VL-VM User Manual Page 57