Asus CUV266-D User Manual download pdf (Page 59)

ASUS CUV266-D User’s Manual 59

4. BIOS SETUP

I/O Device Config

Onboard FDC Swap A & B [No Swap]

This field allows you to reverse the hardware drive letter assignments of

your floppy disk drives. Configuration options: [No Swap] [Swap AB]

Floppy Disk Access Control [R/W]

When set to [Read Only], this parameter protects files from being copied to

floppy disks by allowing reads from, but not writes to, the floppy disk drive.

The default setting [R/W] allows both reads and writes. Configuration

options: [R/W] [Read Only]

Onboard Serial Port 1 [3F8H/IRQ4]

Onboard Serial Port 2 [2F8H/IRQ3]

These fields allow you to set the addresses for the onboard serial connectors.

Serial Port 1 and Serial Port 2 must have different addresses. Configuration

options: [3F8H/IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/IRQ10]

[Disabled]

UART2 Use Infrared [Disabled]

When enabled, this field activates the onboard infrared feature and sets the

second serial UART to support the infrared module connector on the

motherboard. If the system already has a second serial port connected to the

onboard COM2 connector, it will no longer work if you enable the infrared

feature. See IrDA-Compliant Infrared Module Connector in 3.8 Connectors.

Configuration options: [Disabled] [Enabled]

4.4.2 I/O Device Configuration

1 ... 58 59 60 ... 88

No comments

Asus CUV266-D User Manual Page 59