Asus M5A88-V EVO Specifications download pdf (Page 44)

2-26 Chapter 2: Hardware information

Chapter 2

2.8.3 Internal connectors

Drive jumper setting Mode of device(s) Cable connector

Single device Cable-Select or Master - Black

Two devices

Cable-Select

Master

Black

Slave Gray

Master Master

Black or gray

Slave Slave

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA

cable connector. This prevents incorrect insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select”, ensure that all other device jumpers have the

same setting.

1. IDE connector (40-1 pin PRI_EIDE)

The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are

three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.

Connect the blue connector to the motherboard’s IDE connector, then select one of the

following modes to congure your device.

M5A88-V EVO

PRI_EIDE

NOTE:Orient the red markings

on the IDE ribbon cable to PIN 1.

PIN1

M5A88-V EVO IDE connector

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 123 124

No comments

Asus M5A88-V EVO Specifications Page 44