Asus AAM6010EV-T4 User Manual download pdf (Page 21)

AAM6010EV-T4 User Manual

name; the name must not have spaces and cannot begin with numbers. In this case the unique name is

called STATIC1. Select the encapsulation type (LLC or VC); if you are not sure just use the default mode.

Select the VPI and VCI settings; your DSL service provider or your ISP will supply these; in this case the

DSL service provider is using 0,35. Also select the quality of service (QOS); leave the default value if you

are unsure or the ISP did not provide this information. You can also enable Network Address Translation

(NAT) and the Firewall options. If you are unsure, leave these in the default mode.

Based upon the information your DSL/ISP provided, enter your assigned IP address, Subnet Mask, Default

CPE (if provided), and Domain Name Services (DNS) values (if provided). For the static configuration,

you can also select a bridge connection or a routed connection. Since static IP address is typically used to

host WEB servers, you may want to use a bridge connection.

Figure 8 (Static IP Connection Setup)

To complete the connection you must now click the apply button. The apply button will temporarily save

this connection. To make the change permanent you need to click on Tools (at the top of the page) and

select System Commands. At the system commands page, click on Save All.

4.4.1.6 Classical IP over ATM (CLIP, defined in RFC1577) Connection Setup

The Classical IP over ATM (CLIP) support provides the ability to transmit IP packets over an ATM

network, TI’s CLIP support will encapsulate IP in an AAL5 packet data unit (PDU) frame using

RFC1577and it utilizes an ATM aware version of the ARP protocol (ATMARP. TI’s CLIP support only

allows for PVC support; it does not support SVC.

To configure the CPE for a CLIP connection, click on Setup and then click on New Connection. The

default CLIP connection setup is displayed. At the Type field select CLIP and the CLIP connection setup

page is displayed; figure 9 illustrates a typical CLIP configuration. Give your CLIP connection a unique

name; the name must not have spaces and cannot begin with numbers. In this case the unique name is

called CLIP1. Select the VPI and VCI settings; your DSL service provider or your ISP will supply these;

in this case the DSL service provider is using 0,35. Also select the quality of service (QOS); leave the

default value if you are unsure or the ISP did not provide this information. You can also enable Network

Address Translation (NAT) and the Firewall options. If you are unsure, leave these in the default mode.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 37 38

No comments

Asus AAM6010EV-T4 User Manual Page 21