Asus AAM6010EV-T4 User Manual download pdf (Page 31)

AAM6010EV-T4 User Manual

Figure 19 (Static Routing)

The apply button will temporarily save this connection. To make the change permanent you need to click

on Tools (at the top of the page) and select System Commands. At the system commands page, click on

Save All.

4.6.9 Dynamic Routing

Dynamic Routing allows the CPE to automatically adjust to physical changes in the network. The CPE,

using the RIP protocol, determines the network packets’ route based on the fewest number of hops between

the source and the destination. The RIP protocol regularly broadcasts routing information to other routers

on the network.

The Direction determines the direction that RIP routes will be updated. Selecting In means that the CPE

will only incorporate received RIP information. Selecting Out means that the CPE will only send out RIP

information. Selecting both means that the CPE will incorporate received RIP information and send out

updated RIP information.

The protocol is dependent upon the entire network. Most networks support Rip v1. If RIP v1 is selected,

routing data will be sent in RIP v1 format. If Rip V2 is selected, routing data will be sent in RIP v2 format

using subnet broadcasting. If Rip V1 Compatible is selected, routing data will be sent in RIP v2 format

using multicasting.

To enable Dynamic Routing, from the Home screen, click Advanced and under Advanced, select Dynamic

Routing. Figure 20 illustrates a typical Dynamic Route.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

No comments

Asus AAM6010EV-T4 User Manual Page 31