Asus P5N-E SLI User Manual Page 44

  • Download
  • Add to my manuals
  • Print
  • Page
    / 122
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 43
1-30 Chapter 1: Product introduction
P5N-E SLI
R
P5N-E SLI
IDE Connectors
PIN1
PIN1
SEC_IDE
PRI_IDE
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
2. IDE connector (40-1 pin PRI_IDE, SEC_IDE)
The onboard IDE connector is for the Ultra DMA 133/100/66/33
signal cable. There are four connectors on each Ultra DMA
133/100/66/33 signal cable: blue, black, and gray. Connect the blue
connector to the motherboard’s IDE connector, then select one of the
following modes to congure your device.
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66/33 IDE
devices.
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
Drive jumper setting Mode of
device(s)
Cable connector
Single device Cable-Select or Master - Black
Two devices Cable-Select Master
Black
Slave Gray
Master Master Black or gray
Slave Slave
Page view 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 121 122

Comments to this Manuals

No comments