2-24 Chapter 2: Hardware information
3. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4)
Supported by the NVIDIA
®
nForce4™ chipset, these connectors are for
the Serial ATA signal cables for Serial ATA hard disk drives that allows
up to 3Gb/s of data transfer rate.
If you installed Serial ATA hard disk drives, you can create a RAID 0,
RAID 1, RAID 1+0, RAID 5, or JBOD conguration.
Important notes on Serial ATA
The actual data transfer rate depends on the speed of Serial ATA hard
disks installed.
4. Backplane SMBus connector (6-1 pin BPSMB1)
This connector allows you to connect SMBus (System Management
Bus) devices. Devices communicate with an SMBus host and /or other
SMBus devices using the SMBus interface.
Comments to this Manuals