5-20
Chapter 5: OS Installation
14. Press F2_Continue. Drivers for the device controller that you
selected are displayed. Your system boots to run the install program.
The install program starts and your machine begins booting the
complete Solaris operating environment. The following messages
appears some time later, and prompts you to insert each of the
Solaris Driver ITU diskette(s) required to install into your system:
Installing unbundled device driver support
Extracting driver list from tree...
<ITU diskette name> driver-name...
Insert the Driver Update diskette labeled <ITU diskette name>.
Press <ENTER> when ready.
15. Remove the Solaris Device Configuration Assistant Diskette. Reinsert
the SYMHISL Driver ITU diskette that you inserted earlier into the
diskette drive.
16. Press Enter. Packages and/or patches that contain the new drivers
are installed from the diskette onto your machine. Messages about
each installation appear accordingly. When the following prompt
appears:
Insert the Driver Update diskette labeled <SYMHISL>.
Press <ENTER> when ready.
17. Insert the SYMHISL ITU diskette into the floppy disk drive. When the
prompt asking if you wish to create a new instance of the SYMHISL
package appears, respond with N for no. When the prompt asking if
you wish to overwrite the existing instance of SYMHISL appears,
respond with Y for yes.
18. If drivers on other Solaris Driver ITU diskettes are required, remove
the Driver ITU diskette from the diskette drive, insert the next Driver
ITU diskette when prompted to insert it, press Enter, and repeat this
process until all drivers you need are installed.
19. Press Enter. When the installation has completed, the message
“Installation complete” appears.
20. Remove the disk from the floppy disk drive. Reboot the system.
When the Solaris operating environment is finished booting and
running, the new devices whose drivers you installed are available.
Comments to this Manuals