Asus Striker II Extreme User Manual download pdf (Page 27)

ROG Striker II Extreme / Striker II NSE 2-1

2.1 Before you proceed

Take note of the following precautions before you install motherboard components

or change any motherboard settings.

• Unplug the power cord from the wall socket before touching any

component.

• Use a grounded wrist strap or touch a safely grounded object or a metal

object, such as the power supply case, before handling components to

avoid damaging them due to static electricity.

• Hold components by the edges to avoid touching the ICs on them.

• Whenever you uninstall any component, place it on a grounded antistatic

pad or in the bag that came with the component.

• Before you install or remove any component, ensurethat the ATX power

supply is switched off or the power cord is detached from the power

supply. Failure to do so may cause severe damage to the motherboard,

peripherals, and/or components.

Onboard LEDs

The motherboard comes with LEDs that indicate the voltage conditions of CPU,

memory, northbridge, southbridge, and FSB frequency. You may adjust the

voltages in BIOS. There are also an LED for hard disk drive activity and an onboard

switch for power status. For more information about voltage adjustment, refer to

4.4 Extreme Tweaker menu.

1. CPU LED

 

you can select the voltage to display in BIOS. Refer to the illustration below



Normal (green) High (yellow) Crazy (red)

CPU Voltage

1.10000~1.50000 1.50625~1.69375 1.70000~

CPU PLL Voltage

1.50000~1.60000 1.62000~1.80000 1.82000~

STRIKER II EXTREME

CPU_CRAZY

CPU_HIGH

CPU_NORMAL

STRIKER II EXTREME/

STRIKER II NSE CPU LED

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 195 196

No comments

Asus Striker II Extreme User Manual Page 27