2-44 Chapter 2: Hardware information
2.8.4 Installing Fusion Block System accessory
Install your watercooling system to the motherboard using the bundled accessories
to obtain the best thermal solution.
Package contents
1
2
For watercooling system with 3/8” ID tubes
2. Press the clip and connect the tube to the waterblock. When done, release
the clip to tighten the two together.
3. Repeat Step 1 and 2 for another tube. Make sure that both tubes are well
3/8” ID tubes x 2
1/2” ID tube clips x 2 3/8” ID tube clips x 6
The pictures below are for demonstration only. The heatpipe assembly and
motherboard layout may vary with models, but the installation steps remain the
same.
Comments to this Manuals