2-15ASUS RS160-E4/PA4
2.4 Hard disk drives
The system supports four hot-swap Serial ATA hard disk drives. The hard disk
drive installed on the left tray connects to the motherboard SATA ports via SATA
backplane.
To install a hot-swap SATA HDD:
1. Release a drive tray by pushing the
spring lock to the right, then pulling
the tray lever outward. The drive tray
ejects slightly after you pull out the
lever.
2. Firmly hold the tray lever and pull
the drive tray out of the bay.
3. Take note of the drive tray holes.
Each side has three holes to t
different types of hard disk drives.
Use two screws on each side to
secure the hard disk drive.
4. Place a SATA hard disk drive on
the tray, then secure it with four
screws.
spring lock
Comments to this Manuals