Asus WL-160G User Manual download pdf (Page 49)

4. Troubleshooting

ASUS 802.11g Access Point 49

Chapter 4 -Troubleshooting

Problem

The ASUS AP Device Discovery still cannot find or connect to

the ASUS AP after verifying the IP address and LAN cable,

changes cannot be made, or password is lost.

Solution

In case the ASUS AP is inaccessible, you can restore the

ASUS AP’s factory default settings. Use a straightened paper

clip to press the button located in the hole on the back of the

ASUS AP and keep it depressed over 5 seconds. The power

LED will darken and then light up when reset is successful.

Reset to Defaults

The following are factory default values. These values will be present when you

first receive your the ASUS AP , if you push the reset button on the back of the

ASUS AP over 5 seconds, or if you restore factory settings through the ASUS

AP software.

Name Default Value

Wireless - Interface

SSID default

Channel 6

Encryption (WEP) None

Broadcast SSID No

Wireless - Bridge

AP Mode Access Point Only

Wireless - Access Control

MAC Access Mode Disabled

IP Config - LAN

IP Address 192.168.1.1

Get IP Address Automatically Yes

Subnet Mask 255.255.255.0

Gateway (blank)

System Setup - Password

Operation Mode Access Point

User Name admin

Password admin

1 ... 48 49 50 ... 77

No comments

Asus WL-160G User Manual Page 49