Asus P5LD-MR User Manual Page 47

  • Download
  • Add to my manuals
  • Print
  • Page
    / 160
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 46
ASUS P5LD-MR 2-27
3. Serial ATA connectors
(7-pin SATA1, SATA2, SATA3, SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA
hard disk drives.
If you installed Serial ATA hard disk drives, you can create a RAID
0, RAID 1, RAID 0+1, and software RAID 5 conguration using the
Intel
®
Matrix Storage Technology or RAID 0, RAID 1 and RAID 0+1
conguration using the LSI MegaRAID
®
utility embedded on the Intel
®
ICH7R Southbridge.
Serial ATA hard disk drive connection
Connector Setting U se
SATA1/SATA2 Master Boot disk
SATA3/SATA4 Slave Data disk
These connectors are set Standard IDE mode by default. In Standard IDE
mode, you can connect Serial ATA boot/data hard disk drives to these
connectors. If you intend to create a Serial ATA RAID set using these
connectors, set the Congure SATA as item in the BIOS to [RAID]. See
section “4.3.5 IDE Conguration” for details.
Important notes on Serial ATA
You must install Windows
®
2000 Service Pack 4 or Windows
®
2003
before using Serial ATA hard disk drives.
Use only two Serial ATA RAID connectors for each RAID 0 or RAID 1
set.
When using the connectors in IDE mode, connect the primary (boot)
hard disk drive to the SATA1 or SATA2 connector. Refer to the table
below for the recommended SATA hard disk drive connections.
P5LD-MR SATA Connectors
SATA1
SATA2
SATA3
SATA4
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
R
P5LD-MR
Page view 46
1 ... 46 47 48 ... 160

Comments to this Manuals

No comments