ASUS P5LD-MR 4-15
DMA Mode [Auto]
Allows the BIOS to automatically select the DMA mode.
Conguration option: [Auto] [SWDMA0] [SWDMA1] [SWDMA2] [MWDMA0]
[MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Conguration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Conguration options: [Disabled] [Enabled]
4.3.5 IDE Configuration
The items in this menu allow you to set or change the congurations for
the IDE devices installed in the system. Select an item then press <Enter>
if you want to congure the item.
IDE Conguration
Congure SATA As [Standard IDE]
Onboard IDE Operate Mode [Enhanced Mode]
Enhanced Mode Support On [S-ATA]
IDE Detect Time Out (Sec) [35]
Configure SATA As [Standard IDE]
Sets the Serial ATA conguration. When set in Advanced Host Controller
Interface (AHCI) or RAID mode the SATA controller is set to Native mode.
Conguration options: [Standard IDE] [AHCI] [RAID]
The AHCI allows the onboard storage driver to enable advanced Serial
ATA features that enhance storage performance on random workloads by
allowing the drive to internally optimize the order of commands.
If you want the Serial ATA hard disk drives to use the Advanced Host
Controller Interface (AHCI), set this item to [AHCI]. For details on AHCI, go
to: www.intel.com/support/chipsets/imst/sb/CS-012304.htm
www.intel.com/support/chipsets/imst/sb/CS-012305.htm
When in AHCI/RAID
mode, SATA controller
is forced to Native
mode.
The system can fully support Serial ATA II technology only when you set
this item to [AHCI]. Install the Intel SATA AHCI Driver during windows
setup when you congured SATA as AHCI mode. Refer to the section
“6.1.2 Installing the RAID controller driver” on page 6-3.
Comments to this Manuals