Asus CUR-DLSR User Manual download pdf (Page 23)

D1260 CUR-DLSR User’s Manual 17

3. HARDWARE SETUP

Motherboard Settings

3. H/W SETUP

3.6 Central Processing Unit (CPU)

The motherboard has a PGA 370 socket.

WARNING! Be sure that there is sufficient air circulation across the processor

heatsink by regularly checking that your CPU fan is working. Without sufficient

circulation, the processor could overheat and damage both the processor and the

motherboard. The CPU will be unstable if the heatsink is not properly

mounted. Double check the contact.

To install a CPU, first turn off the system and remove its cover. Locate the CPU

socket and open it by first lifting the lever to a 90-degree angle. Carefully insert the

CPU with the correct orientation as shown. The notched corner should point towards

the end of the lever. Because the CPU has a corner pin for two of the four corners,

the CPU will only fit in the orientation as shown. The picture is for reference only.

Once completely inserted, pull down the socket lever while holding down the

CPU. Next, install the specified heatsink.

NOTE: The motherboard automatically sets the correct Bus Frequency and Multiple

for the processor. PGA370 processors provide internal thermal sensing that a socket

mounted thermal resistor is not needed.

CAUTION! Be careful not to scrape the motherboard when mounting a clamp-

style processor heatsink or else damage may occur to the motherboard.

CUR-DLSR

CUR-DLSR Socket 370

Gold Arrow

Socket 370 Pentium III

Socket 370 Terminator

(Use when only one

CPU is installed)

Silver Arrow

IMPORTANT: An optional CPU terminator is required when installing only one CPU.

1 ... 22 23 24 ... 68

No comments

Asus CUR-DLSR User Manual Page 23