Asus CUR-DLSR User Manual download pdf (Page 26)

D1260 CUR-DLSR User’s Manual

3. HARDWARE SETUP

Motherboard Settings

3. H/W SETUP

3.8 Ports and Connectors

WARNING! Some pins are used for connectors or power sources. These are

clearly distinguished from jumpers in the Motherboard Layout. Placing jumper

caps over these connector pins may damage your motherboard.

IMPORTANT: Ribbon cables should always be connected with the red stripe to

Pin 1 on the connectors. Pin 1 is usually on the side closest to the power connector

on hard drives and CD-ROM drives, but may be on the opposite side on floppy

disk drives. Check the connectors before installation because there may be

exceptions. IDE ribbon cable must be less than 46 cm (18 in.), with the second

drive connector no more than 15 cm (6 in.) from the first connector.

1) PS/2 Mouse Port (Green 6-pin PS2KBMS)

The system will direct IRQ12 to the PS/2 mouse if one is detected. If one is not

detected, expansion cards can use IRQ12. See PS/2 Mouse Function Control

in 4.4 Advanced Menu.

2) PS/2 Keyboard Port (Purple 6-pin PS2KBMS)

This connection is for a standard keyboard using an PS/2 plug (mini DIN). This

connector does not allow standard AT size (large DIN) keyboard plugs. You

may use a DIN to mini DIN adapter on standard AT keyboards.

PS/2 Keyboard (6-pin Female)

PS/2 Mouse (6-pin Female)

1 ... 25 26 27 ... 68

No comments

Asus CUR-DLSR User Manual Page 26