Asus CUR-DLSR User Manual download pdf (Page 40)

D1260 CUR-DLSR User’s Manual

3. HARDWARE SETUP

Motherboard Settings

3. H/W SETUP

3.10 Starting Up the First Time

1. After you have made all the connections, replace the system unit cover.

2. Be sure that all switches are off (in some systems, marked with

), and the

power input voltage is set to comply with the standard used in your country

(220V-240V or 110-120V).

3. Connect the power supply cord into the power supply located at the back of

your system unit according to the system user’s manual.

4. Connect the power cord into a power outlet that is equipped with a surge protector.

5. You may then turn on your devices in the following order:

a. Your monitor

b. External SCSI devices (starting with the last device on the chain)

c. Your system power. For ATX power supplies, you need to switch on the

power supply as well as press the ATX power switch on the front of the case.

6. The power LED on the front panel of the system case will light. For ATX power

supplies, the system LED will light when the ATX power switch is pressed. The

LED on the monitor may light up or switch between orange and green after the

system’s if it complies with “green” standards or if it has a power standby feature.

The system then runs power-on tests. While the tests are running, the BIOS

alarm beeps or additional messages appear on the screen. If you do not see

anything within 30 seconds from the time you turn on the power, the system

may have failed a power-on test. Re-check your jumper settings and connections

or call your retailer for assistance.

Award BIOS Beep Codes

Beep Meaning

One short beep when No error during POST

displaying logo

Long beeps in an endless loop No DRAM installed or detected

One long beep followed by Video card not found or video card

three short beeps memory bad

High frequency beeps when CPU overheated

system is working System running at a lower frequency

1 ... 39 40 41 ... 68

No comments

Asus CUR-DLSR User Manual Page 40