Asus CUR-DLSR User Manual download pdf (Page 49)

4. BIOS SETUP

D1260 CUR-DLSR User's Manual 43

4.3.1 Primary & Secondary Master/Slave

Main...

Primary Master [Auto] Item Specific Help

Type [Auto)

Cylinders [ 1026]

Head [255]

Sector [63]

CHS Capacity 84228MB

Maximum LBA Capacity 25598MB

Multi-Sector Transfers [Maximum]

Smart Monitoring [Disabled]

PIO Mode [4]

Ultra DMA Mode [2]

F1 Help ↑↓ Select Item -/+ Change Values F5 Setup Defaults

ESC Exit

←→ Select Menu Enter Select Ê Submenu F10 Save and Exit

NOTE: Before attempting to configure a hard disk drive, make sure you have the configuration

information supplied by the manufacturer of the drive. Incorrect settings may cause your system to

not recognize the installed hard disk. To allow the BIOS to detect the drive type automatically, select

[Auto].

Type [Auto]

Select [Auto] to automatically detect an IDE hard disk drive. If automatic detection is successful, the

correct values will be filled in for the remaining fields on this sub-menu. If automatic detection fails,

your hard disk drive may be too old or too new. You can try updating your BIOS or enter the IDE

hard disk drive parameters manually.

NOTE: After the IDE hard disk drive information has been entered into BIOS, new IDE hard disk

drives must be partitioned (such as with FDISK) and then formatted before data can be read from

and write on. Primary IDE hard disk drives must have its partition set to active (also possible with

FDISK).

Other options for the Type field are:

[None] - to disable IDE devices

1 ... 48 49 50 ... 68

No comments

Asus CUR-DLSR User Manual Page 49