Asus Terminator P-III User Manual download pdf (Page 61)

ASUS CUV4X-D User’s Manual 61

4. BIOS SETUP

I/O Device Config

Onboard FDC Swap A & B [No Swap]

This field allows you to reverse the hardware drive letter assignments of

your floppy disk drives. Configuration options: [No Swap] [Swap AB]

Onboard Serial Port 1 [3F8H/IRQ4]

Onboard Serial Port 2 [2F8H/IRQ3]

These fields allow you to set the addresses for the onboard serial connectors.

Serial Port 1 and Serial Port 2 must have different addresses. Configuration

options: [3F8H/IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/IRQ10]

[Disabled]

UART2 Use Standard Infrared [Disabled]

When enabled, this field activates the onboard standard infrared feature and

sets the second serial UART to support the infrared module connector on the

motherboard. If the system already has a second serial port connected to the

onboard COM2 connector, it will no longer work if you enable the infrared

feature. See IrDA-Compliant Infrared Module Connector in 3.8 Connectors.

Configuration options: [Disabled] [Enabled]

Onboard Parallel Port [378H/IRQ7]

This field sets the address of the onboard parallel port connector. If you disable

this field, the Parallel Port Mode and ECP DMA Select configurations are

not available. Configuration options: [Disabled] [378H/IRQ7] [278H/IRQ5]

4.4.2 I/O Device Configuration

1 ... 60 61 62 ... 92

No comments

Asus Terminator P-III User Manual Page 61