Asus TR-DLSR User Manual download pdf (Page 24)

24 ASUS TR-DLSR User’s Manual

3. HARDWARE SETUP

3.7 Expansion Cards

3.7.1 Expansion Card Installation Procedure

1. Read the documentation for your expansion card and make any necessary

hardware or software settings for your expansion card, such as jumpers.

2. Remove your computer system cover and the bracket plate on the expansion

slot. Keep the bracket for possible future use.

3. Lift the locking tab on top of the slot. If you are installing a long expansion

card, lift the metal card guide also. This card guide is located on the bracket

near the chassis fans.

4. Detach the riser card from the PCI card slot on the motherboard.

5. Carefully insert the golden fingers of the expansion card into the connector on

the riser card.

6. Align the card bracket to the slot opening at the back of the system unit while

inserting the end of the bracket to the slot holding tab.

7. Insert the golden fingers of the riser card to the PCI slot on the motherboard

until it fits in place.

8. Press down the locking tab at the top of the expansion slot to secure the card.

9. If you installed a long expansion card, pull down the metal card guide and fit it

to the other end of the card to hold the card in place.

10. Install the necessary software drivers for your expansion card.

WARNING! Unplug the power supply when adding or removing expansion cards

or other system components. Failure to do so may cause severe damage to both

your motherboard and expansion cards.

Locking Tab

Expansion Card

Riser Card

PCI Slot

1 ... 23 24 25 ... 100

No comments

Asus TR-DLSR User Manual Page 24