Asus TR-DLSR User Manual download pdf (Page 48)

ASUS TR-DLSR User’s Manual48

4. BIOS SETUP

Master/Slave Devices

[User Type HDD]

Manually enter the number of cylinders, heads and sectors per track for

your drive. Refer to your drive documentation or look on the drive for this

information. If no drive is installed or if you are removing a drive and not

replacing it, select [None].

Translation Method [LBA]

Select the hard disk drive type in this field. When Logical Block Addressing

is enabled, 28-bit addressing of the hard drive is used without regard for

cylinders, heads, or sectors. Note that LBA Mode is necessary for drives

with greater than 504MB in storage capacity. Configuration options: [LBA]

[LARGE] [Normal] [Match Partition Table] [Manual]

Cylinders

This field configures the number of cylinders. Refer to your drive

documentation to determine the correct value to enter into this field. NOTE:

To make changes to this field, the Type field must be set to [User Type

HDD] and the Translation Method field must be set to [Manual].

IMPORTANT: If the hard disk was already formatted on an older system, Setup may

detect incorrect parameters. You will need to enter the correct parameters manually,

or use low-level format in case you do not need the data stored on the hard disk. If the

parameters listed differ from the ones used when the disk was formatted, the disk

will not be readable. If the auto-detected parameters do not match the ones that

should be used for the disk, you should enter the correct ones manually by setting

[User Type HDD].

1 ... 47 48 49 ... 100

No comments

Asus TR-DLSR User Manual Page 48