Asus P3C-D User Manual download pdf (Page 28)

28 ASUS P3C-L / P3C-S / P3C-LS User’s Manual

System Memory

3. H/W SETUP

3. HARDWARE SETUP

J1M1

J1M2

RIBS (inside socket)

EJECTOR

RIMM0 (top view)

NOTCH KEYS

CONNECTORS

SDRAMMOUNTING NOTCH

NOTCH KEYS

CONNECTORS

MOUNTING NOTCH

EJECTORRIBS (inside socket)

Screw to secure

riser to case

CAPTIVE NUT

(back of riser)

ATTACH MOUNT

BRIDGE (top view)

ATTACH MOUNT

BRIDGE (top view)

CPU FAN

Screw to secure

riser to case

CAPTIVE NUT

(back of riser)

4. Screw the captive nuts into the attach mount bridges.

WARNING! Do not overtighten the captive nut. Doing so could damage your

motherboard. Tighten captive nuts to no more than 6±1inch/pound.

5. With the ejectors of the DIMM socket (J1M1/J1M2) in the open position and

while holding the riser along its edges, push down gently but firmly on one side

of the memory module until it snaps into place and then do the same on the other

side. The guides on the socket’s ejectors should go through the two mounting

notches on the module and the ejectors should close. If necessary, push the ejec-

tors inward to secure the module in place.

IMPORTANT: When populating both DIMM sockets, the module density on J1M2

must be greater than the one on J1M1. For example, if you are installing a 64MB

memory on J1M1, you must install memory greater than or equal to 64MB on J1M2.

Removing Memory from the Riser

1. Unscrew the captive nuts from the attach mount bridge.

2. Push both ejectors (J1M1/J1M2) outward while holding the module along its side

edges. Pull the module straight up and out of the DIMM sockets on the riser.

1 ... 27 28 29 ... 114

Comments to this Manuals

No comments

Asus P3C-D User Manual Page 28

Comments to this Manuals

Related products and manuals for Motherboards Asus P3C-D