Asus P3C-D User Manual download pdf (Page 34)

34 ASUS P3C-L / P3C-S / P3C-LS User’s Manual

3. HARDWARE SETUP

CPU

3. H/W SETUP

3.6.4 Installing the Processor

NOTE: The following steps assume that you have already attached the heatsink and

installed the URM into your motherboard.

1. Make sure that the processor substrate key is aligned with the Slot 1 connector key.

Locked Position

(push upward)

SECC SECC2/SEPP

CPU fan cable to

fan connector

CPU fan

cable to fan

connector

Lock hole

Substrate Key

Connector Key

3. If your URM is of type A, make sure the locks are in the locked position as shown.

2. Push down firmly but gently the SECC2/SECC/SEPP into the URM until it

snaps into place.

NOTE: The processor edge fingers must be kept parallel to the connector or else

misalignment will occur.

SECC for Pentium II only: Secure the SECC in place by pushing the two SECC

locks outward so that the locks show through the retention mechanism’s lock holes.

SECC2/SEPP: When engaged, the T-bars lock into the slots at the two ends of

the SECC2/SEPP heatsink.

1 ... 33 34 35 ... 114

No comments

Asus P3C-D User Manual Page 34