Asus P3C-D User Manual Page 40

  • Download
  • Add to my manuals
  • Print
  • Page
    / 114
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 39
40 ASUS P3C-L / P3C-S / P3C-LS Users Manual
Connectors
3. H/W SETUP
3. HARDWARE SETUP
3.7.3 Accelerated Graphics Port (AGP)
This motherboard provides an accelerated graphics port (AGP) pro slot to support a
new generation of AGP graphics cards with ultra-high memory bandwidth.
P3C-LS/L/S Accelerated Graphics Port (AGP Pro) Slot
Rib (inside slot)
Rib
20-pin bay
28-pin bay
AGP Card without
Retention Notch
P3C-LS / L / S
If the system has both legacy and PNP ISA cards installed, IRQs are
assigned to PNP cards from those not used by legacy cards. The PCI and PNP con-
figuration of the BIOS setup utility can be used to indicate which IRQs are being
used by legacy cards. For older legacy cards that do not work with the BIOS, you
can contact your vendor for an ISA Configuration Utility.
An IRQ number is automatically assigned to PCI expansion cards after those used
by legacy and PNP ISA cards. In the PCI bus design, the BIOS automatically as-
signs an IRQ to PCI cards that require an IRQ. To install a PCI card, you need to set
the INT (interrupt) assignment. Since all the PCI slots on this motherboard use an
INTA #, be sure that the jumpers on your PCI cards are set to INT A.
Assigning DMA Channels for ISA Cards
Some ISA cards, both legacy and PNP, may also need to use a DMA (Direct Memory
Access) channel. DMA assignments for this motherboard are handled the same way
as the IRQ assignment process described earlier. You can select a DMA channel in
the PCI and PNP configuration section of the BIOS Setup utility.
IMPORTANT: To avoid conflicts, reserve the necessary IRQs and DMAs for legacy
ISA cards (see PNP and PCI Setup under IV. BIOS SETUP. Choose Yes in IRQ xx Used
By ISA and DMA x Used By ISA for those IRQs and DMAs you want to reserve).
WARNING! If you are using an old AGP 2X card (which does not have a retention
notch), make sure that the cards connector pins are seated between the 20-pin and
28-pin bays of the AGP Pro slot. Otherwise, the card and the slot may be damaged or
burnt.
Page view 39
1 ... 39 40 41 ... 114

Comments to this Manuals

No comments