Asus P3C-D User Manual download pdf (Page 47)

ASUS P3C-L / P3C-S / P3C-LS User’s Manual 47

3. HARDWARE SETUP

Connectors

3. H/W SETUP

14) IDE Activity LED (2-pin IDE)

This connector supplies power to the cabinet’s IDE activity LED. Read and

write activity by devices connected to the Primary or Secondary IDE connectors

will cause the LED to light up.

P3C-LS/L/S IDE Activity LED

TIP: If the case-mounted LED does not

light, try reversing the 2-pin plug.

IDELED

P3C-LS / L / S

PARALLEL PORT

OPTIONAL

15) Power Supply, CPU, Chassis Fan Connectors

(3-pin PWR_FAN, CPU_FAN, CHA_FAN)

These connectors support cooling fans of 350mA (4.2 Watts) or less. Orientate

the fans so that the heat sink fins allow airflow to go across the onboard heat

sink(s) instead of the expansion slots. Depending on the fan manufacturer, the

wiring and plug may be different. The red wire should be positive, while the

black should be ground. Connect the fan’s plug to the board taking into consid-

eration the polarity of the connector.

NOTE: The “Rotation” signal is to be used only by a specially designed fan with

rotation signal. The Rotations per Minute (RPM) can be monitored using ASUS PC

Probe (see section 6. SOFTWARE REFERENCE) or Intel LDCM Utility.

WARNING! The CPU and/or motherboard will overheat if there is no airflow

across the CPU and onboard heatsinks. Damage may occur to the motherboard

and/or the CPU fan if these pins are incorrectly used. These are not jumpers,

do not place jumper caps over these pins.

P3C-LS/L/S 12-Volt Cooling Fan Power

CPU_Fan

CHA_FAN

PWR_Fan

P3C-LS / L / S

PARALLEL PORT

OPTIONAL

GND

Rotation

+12V

1 ... 46 47 48 ... 114

No comments

Asus P3C-D User Manual Page 47