Asus P3C-D User Manual download pdf (Page 42)

42 ASUS P3C-L / P3C-S / P3C-LS User’s Manual

Connectors

3. H/W SETUP

3. HARDWARE SETUP

3.8 External Connectors

WARNING! Some pins are used for connectors or power sources. These are

clearly distinguished from jumpers in the Motherboard Layout. Placing jumper

caps over these connector pins will cause damage to your motherboard.

IMPORTANT: Ribbon cables should always be connected with the red stripe to

Pin 1 on the connectors. Pin 1 is usually on the side closest to the power connec-

tor on hard drives and CD-ROM drives, but may be on the opposite side on

floppy disk drives. Check the connectors before installation because there may

be exceptions. IDE ribbon cable must be less than 46 cm (18 in.), with the sec-

ond drive connector no more than 15 cm (6 in.) from the first connector.

1) PS/2 Mouse Connector (Green 6-pin PS2KBMS)

The system will direct IRQ12 to the PS/2 mouse if one is detected. If one is not

detected, expansion cards can use IRQ12. See PS/2 Mouse Function Control

in 4.4 Advanced Menu.

PS/2 Mouse (6-pin Female)

2) PS/2 Keyboard Connector (Purple 6-pin PS2KBMS)

This connection is for a standard keyboard using an PS/2 plug (mini DIN). This

connector will not allow standard AT size (large DIN) keyboard plugs. You

may use a DIN to mini DIN adapter on standard AT keyboards.

PS/2 Keyboard (6-pin Female)

1 ... 41 42 43 ... 114

No comments

Asus P3C-D User Manual Page 42