Asus AAM6000EV Specifications download pdf (Page 58)

Description:

This command describes how we require the far end to log in on this channel. Requiring the other end to log in most

frequently happens when they dial us (rather than the other way round), so this is likely to be one of several channels

which are set using

svc listen

. Because of this, exact names and passwords are not attached to individual channels

but are matched to particular users, as defined using the

user

command. This command specifies that when using this

channel, the user must log on using the specified protocol, and that they must provide any name/password combination

which has been defined for that protocol, using the

user

command. To remove this information on a channel, call

theylogin

with a single argument of

none.

Configuration saving saves this information. By default no login is required.

13.7.20. <channel> welogin

Syntax:

<channel> welogin <name> <password> [pap|chap]

<channel> welogin none

Description:

This command describes how we should log in to the far end when a connection is established.

A name and password are supplied, and whether these should be used with the PAP or CHAP authentication protocol.

CHAP is the default. To remove this information on a channel, call

welogin

with a single argument of

none

. If

chap

specified, we will also log in using

pap

if the other end prefers this. If

pap

is specified we will only log in using

pap

Configuration saving saves this information. By default no login is performed.

13.7.21. bcp

Syntax:

bcp stp|nostp

Description:

This command describes parameters for BCP, the Bridge Control Protocol, which is used to transport MAC (Ethernet)

packets over the PPP link. See the protocol conformance section of this spec for BCP option settings which are not

controllable. If

stp

is specified, the Spanning Tree Protocol is in use by the Bridges, to control bridge loops. In this case

STP frames should be carried over any links using BCP. If

nostp

is specified, STP frames should not be carried.

Configuration saving saves this information. By default STP is not supported.

13.7.22. interface <n> localip

Syntax:

interface <n> localip <address>

Description:

This command describes parameters for IPCP, the IP Control Protocol, when providing the server end of an IPCP

connection. The server knows its own IP address (and may allocate an IP address to the remote end). This command tells

the PPP process, for a particular interface, the local IP address to be associated with the local end.

For interface 1, this should be the same IP address as possessed by the device

ppp_device

in the IP stack. See the IP

dial-in server console example, at the start of this section. If PPP channels are now associated with this interface, remote

users can dial in to those channels and will be connected to the IP stack. They can be allocated IP addresses, see the

command

<channel> remoteip.

Call with 0.0.0.0 to remove any IP address setting. This is the default state.

Configuration saving saves this information

13.7.23. interface <n> stats

Syntax:

interface <n> stats

Description:

- 58 -

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 68 69

Comments to this Manuals

No comments

Asus AAM6000EV Specifications Page 58

Comments to this Manuals

Related products and manuals for Networking Asus AAM6000EV