Asus AAM6000EV Specifications Page 62

  • Download
  • Add to my manuals
  • Print
  • Page
    / 69
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 61
13.9.10. up
Syntax:
up
Description:
Enables ADSL link
13.9.11. show id
Syntax:
show id
Description:
This command displays the vendor id of local equipment and remote equipment. It will not return any message if ADSL
link is not established yet.
14. Reset to Factory Defaults
To reset the router to defaults you need to enter a CLI command. Therefore you will have to connect to the router via
either Console or Telnet (see above for details). Then at the ‘..703 >’ prompt enter the command:
config save default
Then wait whilst the default settings are loaded.
Please note: If you’ve changed the LAN IP address of the router then reseting to factory default will rest the router to
192.168.7.1 and hence kill your telnet connection. You will then need to go in via the console to change the IP address.
15. Appendix A Product Specifications
PC interface 10Base-T Ethernet through RJ-45 connector
ADSL interface ADSL line through RJ-11 connector
Console Port RS-232
Standard Compliance ANSI T1.413 issue2
ITU-T G.992.1(Full rate DMT)
ITU-T G.992.2(Lite DMT)
ITU-T G.994.1(Multimode)
RFC 1483 BPDU(Bridge Ethernet over ATM PVC, LLC/SNAP)
RFC 1483 RPDU(Routed IP over ATM PVC, LLC/SNAP)
RFC 1577(Classic IP over ATM, MTU=1500)
RFC 2364(PPP over ATM)
ATM Forum INU 3.0, 3.1 and 4.0 signalling***
ATM Forum ILMI 4.0***
ATM Forum LANE 1.0 client, MTU=1516, over SVC only***
ATM supports AAL5, AAL3/4 and AAL0
ATM Traffic shaping supports CBR and UBR
OAM F4 and F5 segment end-to-end loopback are supported(F4 on all VPIs, F5 on VIP 0
only)***
Transparent Bridging features conformance to IEEE 802.1d and supports spanning tree protocol
and bridge filters
- 62 -
Page view 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68 69

Comments to this Manuals

No comments